The unit of Size I(50)
-
- Posts: 5
- Joined: June 10th, 2021, 9:01 am
The unit of Size I(50)
Hi, the unit of Size I(50) in the Blob table is "min", can I change the "min" into "sec" ? because some values cannot reach 1 min.
Re: The unit of Size I(50)
If the values in minutes are to small to be displayed with the default 2 decimal places, you may right click on the Column Header "Size I(50)". A small window will pop up and allow you to increase the decimal places to be displayed.
To display values in seconds, you may add a CLIC column with the following expression
Note that the units of Size I and II are based on Configure > Settings > Axes > Axis Unit. The above CLIC expression only works with the default settings.
To display values in seconds, you may add a CLIC column with the following expression
Code: Select all
Size_I[50.0]*60
-
- Posts: 5
- Joined: June 10th, 2021, 9:01 am
Re: The unit of Size I(50)
I have tried, but the value of Size_I[50.0]*60 may be wrong. For example, Size_I[50.0] is 1 min, but the Size_I[50.0]*60 is 300qtao wrote: ↑February 15th, 2023, 12:05 pm If the values in minutes are to small to be displayed with the default 2 decimal places, you may right click on the Column Header "Size I(50)". A small window will pop up and allow you to increase the decimal places to be displayed.
To display values in seconds, you may add a CLIC column with the following expression
Note that the units of Size I and II are based on Configure > Settings > Axes > Axis Unit. The above CLIC expression only works with the default settings.Code: Select all
Size_I[50.0]*60
Also, the unit of "sec" can not be found. In "Axis Unit", just "Time" and "pixel" is available. The sec or min can not be adjusted.
what is the else method? To exchange 1 min to X sec
Re: The unit of Size I(50)
The CLIC column simply multiplies the value by 60. You may delete the *60 part and check what is reported. If it still reports a wrong value, please share the version of your software and a screenshot of the Blob Table.
-
- Posts: 5
- Joined: June 10th, 2021, 9:01 am
Re: The unit of Size I(50)
As you see in the attached figure, I want to change the "min" to "sec" in the "Size Ⅰ(50)(min)" . Is there any method to achieve it?
- Attachments
-
- Capture3.PNG (77.85 KiB) Viewed 5023 times
Re: The unit of Size I(50)
The Sec column in the figure already reports values in seconds.
Note that Size I is always a multiple of modulation period. It looks like the modulation period is 60s. If so, Size I values will be a multiple of 60s.
Note that Size I is always a multiple of modulation period. It looks like the modulation period is 60s. If so, Size I values will be a multiple of 60s.
Re: The unit of Size I(50)
Note that there are Size II statistics for the second column.